BMW Werkz banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
My 99 528 i ive noticed that after especially wet conditions the accesory belt pully whines like the bearings are shot , to test i shot a bit of lithium grease and the noise went away- so due to mileage i ordered the pully assem. but now im wondering how in the hell do i relieve pressure / un tighten the belt itself enough to replace this part??? thanks to any insight offered- ROCCO
 

·
Help from over the pond
Joined
·
3,239 Posts
Just undo the tensioner bolt.....but mark the position of the old one before you undo it, then marry up old and new and mark the new one and replace it marrying up the mark you made on the engine.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top