brettski

Hey buddy, how are you doing? Talk to yu soon!

Do me a favor my best Aussie friend...
Find me also on B----------b.com... Full support from me... Just mention "DABSY" when you register... Or introduce yourself in the New Member section

I intend too, and thanks very much. I guess years looking at worn stuff, and design took its toll... Brian.G

I had no Major issues with swap. I did learn one thing and that is when you pull the motor with the Trans still attached hand at least 4 buddies standing by to help. I built my own hoist frame out of 4x6 lumber on castors. The main thing is reconnecting the drive shaft to trans then attach the rear. My shaft came up 1" short and that was caused the motor leaning forward causing that 1" gap.

I haven't seen GSD posting much on here for the last 3 -4 months, then he sweeps back in guns blazing, and JTP, well I can't figure out what his issue /angle is? I try to stay out of the non prductive BS that goes on, but I have pulled GSD up a couple of times.
I am not sure what you or I can do to cool the war of words, but GSD does have the unfair advantage of being a moderator on this site. So tread carefully.

Hiya pal... This "Spat" between GSD and JTP is gettin out of hand, do you think?
DAZ