BMW Werkz banner

separating motor from auto trans

1K views 4 replies 3 participants last post by  rvaughnp 
#1 ·
What else needs to be done other than removing trans from motor?
Are there bolts on the flywheel like an american motor?

Thanks,

rvaughnp
 
#2 ·
I've actually done this before!! There are bolts on the fly wheel, my question is are you removing the motor from the car or the tranny, or are they both out of the car?

Besides all the torx, thats bout it. That and a large pry bar! Make sure you get all the torx, if I do remember correctly we forgot one, but got it eventually.
 
#4 ·
There should be a rubber bung at the bottom of the bell housing remove this, turn the engine over by means of the bottom pully, and at the same time shone a torch in the hole as you turn the engine you will see the bolts appear I think there's 4X
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top