I have brought a 1995 E36 328i auto. that had a major wiring meltdown due to the typical trunk wiring issue.
Because of this melt down i have spliced in a new loom from a 1995 325i.
I have already sold this car on but only once its all repaired so the pressure is on.
my issue is i have NO central locking what so ever and im not sure if its the ZKE module causing it or a wiring muck up on my behalf.
when i operate the drivers door lock with the key i can here a relay switch inside the zke module.
All my fuses are good.
after doing some testing i have found that i am not getting any voltage from pin 9 on connector X13252. going by the bently manual at this link http://www.bimmerwerkz.com/forum/3-s...pdf-67601.html
this is the lock signal wire.
does anyone have any ideas for me or even be able to explain the operation of the locking system for me.
eg when you lock the car this voltage is sent here causing this and this to happen.
thanks heaps guys.