Says its for a 6 banger

[bigred318]

hey i think this might fit on my 94 318is http://cgi.ebay.com/ebaymotors/ws/eBayISAP...item=2467587603 it has the first pipe right out of the throttle body, with the place on the side of the tube for the temp sensor(i think that is what it is) to go in, then a silicon hose for the mass air flow sensor, then the rest of the piping. But if i would instal this would it go down like under my left head light or what? how big is intake piping usually so i can make sure itll fit between all my shit and my ATF cylinder thing.. thats where i would feed it down right? or do i instal it differently? complete installation tips would be great! like what i have to take out and stuff, maybe this wont even fit my car!...

David

[bimmerfan620]

thats similar to my intake, but I think thats the cheap version of it. I paid $120 for mine, and there is a cheaper version were there is a fake K&N filter and the piping is also cheaper material. Plus it won't fit your 4 cylinder, it's for the I-6 only, and the bends won't work with your car.

[Autotechnica]

Once again, it won't fit. Didn't you already start another thread on this topic?

You have to get one made for 318. 6 cyl intake will NOT fit.

Bry

[El Presidente]

The four cylinder models have a square connection at the sensor, whereas the six's are round. You need a round-to-square adapter.

[bimmerfan620]

or you could use duct tape..... but I am not recommending this nor do I believe it will work 100% correctly either.. but if you want to get a part that isn't for your car then you can go ahead and do the above mentioned... kapeesh??? you'll find something, just be patient.

[Furious]

david , you gotta get one for your car. i really suggest making one, it will be cheaper and you can adapt it however you wish.

[Andrewsd1985]

Once again, as in your other thread it does NOT go by your power steering pump, it goes where your horns are.

[Mattitjah]

bigred318: The one you posted before would fit just fine. This one won't.