obc clock setting

[tjball]

I have just acquired said BMW and unfortunately handbook was not supplied. I need to set the clock as it is incorrect however following a search none of the obc ? seem to relate to the one in my vehicle, it only reads date and time and temp. Button configuration is as follows from left to right Temp, C/F, Hr/dat, Memo, Set, Hr,Min. any advice appreciated.

Thanks in advance

TJ

[M3Daemon]

You can set the time by pressing the "set" and the "clock" button at the same time for about 2-3 sec. Then just use the multiple of 10s block on the left to set the digits. Same applies to date.
Another way would be to take it out and disconnect it, in that case it will automatically let you input everything, once you connect it back.





Daemon

[tjball]

Sorry i may be being a bit dumb here but i do not have a multiple of tens button and also no clock button as such it is a date/time button the buttons are as listed in original posting.

Many thanx

TJ

[M3Daemon]

Originally posted by tjball@Apr 10 2004, 03:44 PM
Sorry i may be being a bit dumb here but i do not have a multiple of tens button and also no clock button as such it is a date/time button the buttons are as listed in original posting.

Many thanx

TJ

Oops, in this case I can't help you, haven't seen an OBC like that before sorry...





Daemon

[tjball]

thanks anyway for trying

anyone else got any ideas

if its any help this is a uk car

[dutchbmw]

Can you post a pic of the clock unit?

[tjball]

Good thinking and here it is

[M3Daemon]

Why don't you try pressing the SET and the HR/DAT button together for over 2sec and then increment the hours/minutes with the two buttons on the right?



Daemon

[dutchbmw]

That's the way to do!