BMW Werkz banner

valve cover

1K views 2 replies 3 participants last post by  silversled 
#1 ·
can any one tell me where i can find the specs on the torque i need to tighten my valve cover
 
#3 ·
yes the valve cover gasket you barely even need a wrench on...you could almost do that with with your bare hands/fingers...very little torque is required..otherwise you run the risk of excessively compressing the gasket and thus forcing a leak after the engine heats up.....make sure you tighten in the proper order as well....good luck there
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top