New Mods For My E30

[BMWJNKY]

This week I did some more mods on my E30. I installed an Ireland Engineering strut tower bar and Ireland Engineering poly engine mounts. The engine mounts were a pain to install but the strut bar was cake.

[htp.bmw]

AJ's320i,

Looks very nice and clean. I like the new mods, they look vey nice. I have a favor to ask you, would there be any way you could take your intake off (too the manifold) so i could see the lines underneath, ive installed a new engine and Im not positive on where they plug in If you could do this It would save me alot of time and troubles

thank you

-Casey

[BMWJNKY]

Originally posted by htp.bmw@May 1 2005, 06:48 PM
AJ's320i,

Looks very nice and clean. I like the new mods, they look vey nice. I have a favor to ask you, would there be any way you could take your intake off (too the manifold) so i could see the lines underneath, ive installed a new engine and Im not positive on where they plug in If you could do this It would save me alot of time and troubles

thank you

-Casey

[snapback]339947[/snapback]

What hoses are you trying to hook up?

[htp.bmw]

Originally posted by AJ's320i+May 1 2005, 07:13 PM--><div class='quotetop'>QUOTE(AJ's320i @ May 1 2005, 07:13 PM)</div><div class='quotemain'><!--QuoteBegin-htp.bmw@May 1 2005, 06:48 PM
AJ's320i,

Looks very nice and clean. I like the new mods, they look vey nice. I have a favor to ask you, would there be any way you could take your intake off (too the manifold) so i could see the lines underneath, ive installed a new engine and Im not positive on where they plug in If you could do this It would save me alot of time and troubles

thank you

-Casey

[snapback]339947[/snapback]

What hoses are you trying to hook up?

[snapback]339953[/snapback]

[/b][/quote]


The hoses im trying to hook up are the ones comming out of the air intake where the throttle is, the 2 on the bottom they have to do with vaccum I assume but not sure.

and near the back of the engine twords the transmission there is a T section that comes out of the engine into a T and I dont know where the hoses go after that

[htp.bmw]

bump

please anyone im at a loss here

[Fox]

Good job, im jealous, i always wanted to setup my e30 with a complete IE line of products... i love that company.

[draculia]

i fairly recently put the IE motor and tranny mounts on mine. i have a set of their springs waiting till i have enough time to put them on as well.

very clean engine compartment btw!!