Help only 4 days till the street legal drags !!!!!!!!!

[dirty87e30m20b27]

I am helping a friend put his 2.7I engine in and ran into a hiccup the 88 seta bottom end and trans came out of a 1988 528. The problem i am having is the tail housing output excepts the large flex disk and the drive shaft is the small flex disk take the small flex disk?
Can i swap the the tail output flange from the other G260 i have with the small output flange????????

[m20enginebuilder]

Originally Posted by dirty87e30m20b27

I am helping a friend put his 2.7I engine in and ran into a hiccup the 88 seta bottom end and trans came out of a 1988 528. The problem i am having is the tail housing output excepts the large flex disk and the drive shaft is the small flex disk take the small flex disk?
Can i swap the the tail output flange from the other G260 i have with the small output flange????????

Yes, if the spline count on the output shaft is the same as the output flange splines.